Job Description Summary
Product quality review associated with the manufacturing process. Impacts quality of own work and the work of others on the team. Executes standard operational/technical tasks typically subject to instructions and work routines. There is latitude to rearrange the sequence to complete task/duties based on changing work situations.
Job Description
Requirements/Requirements
- Perform visual inspection and dimensional control of all incoming components from wind farms or suppliers.
- Perform non-destructive tests on gear and shaft parts (inspection for magnetic particles and penetrating liquids)
- Apply the UT technique to identify potential shaft defects as needed.
- Be able to perform standard quality control checklists and measurements according to drawing specifications in the repair shop.
- Mastery of the use of metrological precision tools for inspection (micrometers, rugosmeters, hardness tests, UT, 3D measuring devices/laser scanning)
- Supervision of the gearbox load test procedure, monitoring temperatures, vibrations, cleanliness and oil pressure.
- Perform the electrical tests of the cabinets mounted on the refurbished Nacelles, Hubs, as well as carry out the final operational tests of the unit.
- Occasionally, it is necessary to work in narrow areas using ladders, platforms, scissor and arm lifts, more than 4 m above the ground.
- Possess in-depth knowledge and the ability to use all the tools associated with assembling units according to the required specifications:
- Forklifts.
- Mobile elevating work platforms
- Lifting equipment, wall cranes and bridge cranes
- Hydraulic and electric tools/torque wrench.
- Other tools include, but are not limited to, impacts, drills, magnetic drills, drills, angle grinders, sanders, basic hand tools (manual and pneumatic)
- Measuring tools, gauges, oil washing equipment.
- Uses of hand tools
- Read and understand mechanical design, engineering drawings.
- Follow all EHS guidelines and policies.
- Follow good environmental practices and waste management procedures. Separate the waste in the corresponding containers in the Repair Room.
- Use and management of Quality documentation
- Traceability
- Calibration
Required Qualifications
- School Diploma of Mechanics, Electricity and/or Electronics (FP2 in Spain)
- Minimum of 2 years of experience working in a repair shop. Preferably from the Wind or Aeronautical Sector.
- Knowledge of ALSPA MD 2000 Frequency Converter
- Knowledge of ISO, AGMA and other standards applicable to the design, repair and failure modes of reducers and shafts.
- Knowledge of ISO 9001, 14001 and 45001 Standards.
- Be able to understand and read the lubrication analysis, according to ISO 4406.
- Complete knowledge of bearing and gear mounting procedures and bearing clearance tolerances.
- Be able to inspect using borescopic devices.
- Knowledge of vibration and temperature measurement devices, being able to understand data and readings from vibration monitoring equipment and data trends.
- Level B2 in English
Desired Characteristics
- High ability to read, understand and follow mechanical, engineering drawings
- It is also essential to have previous experience and certification in handling forklifts, personal lifts, and overhead cranes.
- Self-motivated to work with a minimum of guidance and willingness to learn from others
- END Level II certification training.
- UT Level II Inspection Certification Training
- CAT II Vibration Analysis Certification Training
Additional Information
Relocation Assistance Provided: No